how to make paper mold and deckle

Best answer


Instructions Power tools should only be used by adults. Cut the pine board into eight 7 inch pieces. Sand the cut ends as needed. Lay out the cut pieces to make the frame. This should make a 5 X 7 inch moldanddeckle. Drill a pilot hole in the ends. Insert screw into the the drilled holes and tighten with a screw driver.

People also ask


  • How to make a mould and deckle for handmade paper?

  • Make a Mould and Deckle for Handmade Paper 鈥?Cheap, Quick Dirty 1 CUT THE SCREENING Cut down the hardware cloth and window screening, using your wire cutters and junky scissors. … 2 STAPLE Find the flattest side of one picture frame. Layer the hardware cloth and window screening on the frame. … 3 TRIM, DUCT TAPE, WEATHERSTRIP TAPE

  • What is the difference between a mold and deckle?

  • The mold is a frame covered with metal or nylon mesh, and the deckle is the frame that sits on top of the mold. The paper is formed on the mold, and the deckle is used to create straight edges on the paper sheet. You can purchase a mold and deckle from craft and art supply stores, or make one yourself.

  • How do you make a deckle?

  • The way a deckle works is you have two frames. One will have a mesh on it and the other will be empty. You take the mesh covered one and put that mesh lined side facing up like in the picture. Next place the empty frame on top.

  • How do you get mold out of deckle?

  • Remove the top, empty frame from your deckle by carefully pulling straight up. Turn your deckle over onto a piece of your scrap fabric on top of a towel. Use a sponge to soak up excess water in your paper sheet through the mesh of your mold. You can wring the excess water back into your dishpan.

    Add a Comment

    Your email address will not be published.