how to make paper mold and deckle

Best answer


Instructions Power tools should only be used by adults. Cut the pine board into eight 7 inch pieces. Sand the cut ends as needed. Lay out the cut pieces to make the frame. This should make a 5 X 7 inch moldanddeckle. Drill a pilot hole in the ends. Insert screw into the the drilled holes and tighten with a screw driver.

People also ask


  • How to make a mould and deckle for handmade paper?

  • Make a Mould and Deckle for Handmade Paper 鈥?Cheap, Quick Dirty 1 CUT THE SCREENING Cut down the hardware cloth and window screening, using your wire cutters and junky scissors. … 2 STAPLE Find the flattest side of one picture frame. Layer the hardware cloth and window screening on the frame. … 3 TRIM, DUCT TAPE, WEATHERSTRIP TAPE

  • What is the difference between a mold and deckle?

  • The mold is a frame covered with metal or nylon mesh, and the deckle is the frame that sits on top of the mold. The paper is formed on the mold, and the deckle is used to create straight edges on the paper sheet. You can purchase a mold and deckle from craft and art supply stores, or make one yourself.

  • How to make your own deckle?

  • To make the deckle, cut the foam strips to fit along the inside edge of the 鈥渨indow鈥?on the other frame. Use a staple gun to attach the foam strips at 1-inch (2.5 cm) intervals. *Note: Your mould and deckle will wear over time, and the wire mesh may sag. This is why professional equipment has an extensive ribbing system.

  • Is this mould&deckle paperwork beautiful?

  • This mould deckle is not exactly beautiful 鈥?actually, it鈥檚 ugly 鈥?but it sure does the job when you鈥檙e on a budget! At its most reduced form, a hand mould and deckle (in western style papermaking) is simply 2 separate frames of the same size. One happens to have some sort of screening attached (the mould).

    Add a Comment

    Your email address will not be published.