how to make a 3d rose out of construction paper

Best answer


1. Download and print the paperrosetemplate onto red paper or choose another color for other types of 3Dpaperflowers (or just other colors of roses). 2. With scissors cut out one of the spirals. 3. Roll the spiral, beginning from the outside. 4. Roll the entire spiral until you get to the center.

People also ask


  • How to make a DIY paper rose?

  • Take one A4 size craft paper and fold diagonally to make a square Trim and remove the excess. Now you can cut the left over square piece into four smaller pieces Take three of the smaller square pieces of paper for making rose

  • How do you make a two-tone rose?

  • If you want to make a two-tone rose, try carefully brushing the folded flower with a bit of watercolor paint. A white paper rose with flecks of red is especially pretty. Fold your paper in half horizontally. Unfold, then fold the paper in half vertically. Unfold once more.

  • How do you make a 4×4 with construction paper?

  • Cut out 4 4 in 4 in (10 cm 10 cm) squares from construction paper. Pick your preferred color of construction paper. Use a ruler and a pencil to mark out the squares. Then cut out the 4 squares using scissors.

  • How do you make leaves for an origami rose?

  • To make leaves for your origami rose, you’ll need a square of green paper that is the same size as the red paper you used for the rose petals.

    Add a Comment

    Your email address will not be published.